Free U.S. Shipping | Made in USA
📦
Free U.S. Shipping | Made in USA 📦
Honda S2000 Parts & Accessories
Driven by purpose.
Featured Parts
UPDATE 4/9/26 | SHIPS WITHIN ONE WEEK
The very first exhaust hole plug for AP2’s is finally here. This cover was modeled with CAD using 3D scans for the most precise fit. The cover slides into the bumper for a secure fit, and there are three mounting tabs that will use 3M VHB to secure the cover to the bumper. The covers will be sanded down and primed, ready for paint.
Material: ABS
Includes:
- Primed Exhaust Hole Cover
- 3M Automotive Exterior Attachment Tape
- Adhesion Promoter
Over 100 Pairs Sold | Ships in 2 Days or Less
Window deflectors to help reduce the aggressive wind buffeting that occurs when driving with the windows down on S2000’s. While the buffeting doesn’t result in painful acoustics, a lot of wind still gets into the cabin and creates a parachuting effect. This is very noticeable at high speeds on track days.
Also, very effective in reducing wind noise with the windows up when a hard top is on. Redirects air from shooting into the small pocket on the rear most edge of the window where the hardtop meets the window molding.
Below you can find the CFD Analysis I ran on an S2000 model with and without the deflectors installed.
Attached with included 3M VHB Double Sided Tape. Sold as a pair.
Material: ASA Glass Fiber Reinforced
Made in California
As a longtime owner of my S2000, I love every part of it, except for the "cup holders". I ran the Modifry cup holder mount in the passenger footwell but then it still felt pretty useless to have a large compartment in the center console that didn't have a proper divider.
Meet the upgraded cup holder insert that I designed for the AP2 center consoles. It is wider and deeper than the OEM cup holders, it doesn't taper to a smaller width like the stock one. I also designed it to accommodate the large cups we get from fast food restaurants these days. Rather than trying to squeeze two small sized cups, the divider was designed to have 5 different positions to accommodate whatever sized cup you have. Having a solid divider also allows you to use one of the pockets to store items.
It is properly reverse engineered to use the stock push button of the OEM cup holder; the tolerances are 1:1 of the OEM cup holder, you will be using the stock screws. Everything from the mounting ears to the slight taper of the rail section for the door is present. This cup holder is 3D printed in ABS. I highly value quality so I print these slowly for the best finish.
Features:
- Modular solid divider
- Straight walled pockets for maximum storage space
- 8mm deeper pockets (maxed out to the frame)
- Retains the sliding door and button
- 3D Printed in ABS
Instructions: Link
Made in California
Current lead times are 3 days till shipped or less.